Electrician Talk banner

Enerpac GB Cyclone Bender, Repair- Help

3K views 0 replies 1 participant last post by  Wirenuts1 
#1 ·
Ok, so I'm trying to repair my B2000 Cyclone bender... The control box was smashed and it took out a resistor on the circuit board inside the Bender...

www.312Electric/images/Cyclone/Enerpacboard.JPG

Here is a picture of the board, R5 is the resistor,,, located on the lower right hand corner... its the crunchy looking one... lol

I was hoping someone with the same Cyclone bender could take a picture of their board OR read me off the color bands on the resistor so that I can repair my board....

Hope this works... :blink::)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top