Electrician Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. General Electrical Discussion
    What size feeders for a 3 Phase/4 Wire 208 volt, 200 amp service, roughly 375-400 feet away. No continuous loads 1 set of 500 MCM? Thanks
  2. General Electrical Discussion
    The house I recently purchased has a FULL GE panel rated at 200A. The area seems to be prone to surges. While researching a whole house surge protector. Even an external protector requires a DP 30+ amp breaker. My plan is to install a sub panel next to the existing panel. I would think that...
  3. Canadian Electrical Forum
    Wondering about the rules on this. House load is about 60 Amps but plan on adding a future garage/shop. Here's the info I have: Transformer to meter on the house is 360 ft buried. cable is 3c 4/0 aluminum Regular 240 v service for the house load is 60 A for now Inspector came through and...
  4. General Electrical Discussion
    I am upgrading a electrical service to 200 amps. The service is overhead. I am planning to run conduit from the meter to the Panel along the siding and enter into the crawl space under the residence. It then will turn up into the bedroom to the panel which is next to the door. What i am not sure...
  5. Tools, Equipment and New Products
    Does anyone know if anyone makes an Airtight 200amp Load Center? My client has requested to have one if there is one. They have well water that is absolutly rittled with hydrogen sulfide. It kills there stuff pretty quick apprently. They do not want to move the box just updated. And the box is...
  6. General Electrical Discussion
    I understand that a minimum wire size of #3 or #2 aluminum would be sufficient for installation and wiring from a natural 20K generator and if so, does this apply to a 100 amp output to the switching panel before the main circuit breaker loadcenter? It is also stated that the max ampere output...
1-6 of 6 Results
Top