Electrician Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results
  1. General Electrical Discussion
    Hi everyone, I am new to soldering and i’m having some troubles cutting off the extra component leads ( I am using a through-put solder-able breadboard). At first, I was able to get away with using my basic wire strippers to cut the resistor leads. However, I have four HC-SR04 ultrasonic...
  2. Tools, Equipment and New Products
    I have been involved in a project where I am reading the 120 V coming from a supply. Since input is AC, firstly I converted it to DC using full bridge, now that I used a voltage divider. I am using two resistors one of 20 k and otherone with 800 ohm, As per this VDR calculator for input of 120...
1-2 of 2 Results