Electrician Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. General Electrical Discussion
    This box has been installed at an area where 18 wheelers load up on chemicals and such as you can see its obvious as hell that if anyone works on that box and a truck is there it wont clear the clearances needed also feom my point of view that is a safety hazard since if you are facing against...
  2. UK Electrical Forum
    Morning folks, I've been roped into a bit of a house clearance before some work can get started on a property. Worried about kicking up dust and the like and I'm keen on some mask protection. Does anyone have any brands they favour for this kind of thing? Thought a multi-pack similar to these...
  3. General Electrical Discussion
    I need to install a sub panel in a house. I want to install it in the mechanical room but i am not sure how article 110.26(E)(1) reads. The article reads, "Dedicated Electrical space. The space equal to the width and depth of the equipment and extending from the floor to a height (6 ft) above...
  4. General Electrical Discussion
    Ive seen this topic discussed a couple times but not found a for sure answer. Does a Pergola require any clearances to overhead services? I think it comes down to if you consider the top a pergola a "roof". Personally I don't think should be considered a roof and therefore would not require any...
  5. Canadian Electrical Forum
    Hi Everyone, I'm sure you've heard it many times before... Here is the situation: The home was built in 1961, the basement renovated in 2011. Panel was upgraded in 2011 to a 200 amp Stab-Lok panel (ugh.. I hate removing these covers) and moved to a different location. The room was then built...
  6. NEC Code Forum
    Does anyone know if there is a minimum height requirement from the ground for switchboards / panelboards? The question is in regards to an old 3 phase panel that is sitting directly under a meter pan. The original installation did not have a main breaker (among other problems) The panel now...
1-6 of 6 Results
Top