Electrician Talk banner
1 - 16 of 16 Posts

·
Registered
Joined
·
1,576 Posts
Discussion Starter · #1 ·
I'm looking for a handheld stud punch for half inch. I need to knock out half-inch holes into 50 light fixtures. Does anyone know of such beast? I also looked at Greenlea stud punches but they start at three quarters of an inch. Damn SIRI!!
 

·
Registered
Joined
·
1,544 Posts
The Greenlee 709 stud punch punches a 7/8" diameter hole. I assume you were talking about 1/2" trade size (7/8") and not an actual 1/2" hole?
 

·
Registered
Joined
·
146 Posts
We use an ideal set for a drill. Not handheld like you asked but a hell of a lot easier. Does 1/2" 3/4" and 1". Awesome set to pick up
 

·
Super Moderator
Licensed Electrical Contractor
Joined
·
11,796 Posts
Well, Sal was on today midday and still has not come back and clarified if it is 1/2" trade or nominal.
Sal, which is it???
 

·
Registered
Joined
·
3,450 Posts
I could swear someone already said that.


Oh, there it is. From post #2.
I simply saw your post and looked for a link for the guy since it's obvious he doesn't know how to google for himself. If that interfered with you getting a pat on the back from the OP, then you'll have to take that up with him.
 
1 - 16 of 16 Posts
Top