Electrician Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,576 Posts
Best way ever!!
Step one: one prefabed 90 one trade size larger then your conduit that you need to bend sliced open on its side to create two halves.
2) tape one end with a wet rag inserted inside and the offer just taped
3) heat pipe till it can bend without kinking. This takes practice to know when it's ready
4) place pipe inside radius of prefabed 90 elbow.
5) Velcro pipe to the elbow
6) proceed to spray conduit with cold water.

NEVER FAILS! AND ALL THE BENDS ARE THE SAME..
Works great on 4" PVC SCHEDULE 80
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top