Electrician Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
60 Posts
For the first time I attempted to bend a 90 with 2" pvc but it kinked up like crazy after removing it from my hot box. I'll just use a premade 90 when I do the job I needed it for, but if you've made a 90 with 2" could you give me any tips, thanks!
a good set up from the start i.e. a bending table and not overheating the conduit, the correct shoe to maintain your radius. Barring that a clean flat surface of concrete, find or make a corner to maintain the 90, a sheet of plywood will work also, wet rags to cool the pvc and patience.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top