Electrician Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
201 Posts
Discussion Starter · #1 ·
For the first time I attempted to bend a 90 with 2" pvc but it kinked up like crazy after removing it from my hot box. I'll just use a premade 90 when I do the job I needed it for, but if you've made a 90 with 2" could you give me any tips, thanks!
 

·
Registered
Joined
·
201 Posts
Discussion Starter · #13 ·
Wow, not much love for the hotbox, but I understand. I've used it a few times and it's been a helpful tool. I will admit I wasted a couple of hours learning how to use it though. I like it for underground but it is time consuming to do more involved bends or at least bends you want to look good. Thanks for the tips about using water, taping the ends, and sliding the pipe in and out of the box to heat a longer section.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top