Electrician Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
283 Posts
You would be better off finding the center of whatever angle you are using and marking your bender for it. Its nice to have that anyway for common angles. The notch is the center of a 45 and the star is the center of a 90. I bend 4 points like they are 2 offsets in different directions.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top