Electrician Talk banner
1 - 4 of 4 Posts

·
RIP 1959-2015
Joined
·
10,750 Posts
I have found that by the time I have to change the blade, the tool has used it's usefull life.

It usually binds in the handle after that.

The apprentice on the job last week was able to make a useful tool out of the six garbage roto strip tools I had in my graveyard though.
The best way to go, is cut off that stupid clamp, drill and tap the pin hole for a 1/4x20 by 1" hex screw, works great after....:thumbsup:
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top