[B4T]

Someone asked me about the wiring for load shedding.. here it is..

 

[DIYer4Life]

Is that for the new system?

Don't they use a transformer somewhere because the switching circuits for the contactors is low voltage now instead of 120V?

 

[B4T]

Is that for the new system?

Don't they use a transformer somewhere because the switching circuits for the contactors is low voltage now instead of 120V?

You are correct... good point.. :thumbsup:

Now you need a transformer to power the module..

 

[DIYer4Life]

You are correct... good point.. :thumbsup:

Now you need a transformer to power the module..

Where does that get connected? I've never done one of the new ones, only the old 120V.

 

[B4T]

Where does that get connected? I've never done one of the new ones, only the old 120V.

I'm trying to find a pic of the wiring... so far nothing..

 

[nrp3]

If you can't find it, I just bought the new type switch and the PMM starter kit. I'll take some pictures if we need them.

 

[donselec]

it was just a bj...look what this idiot we have now is doing to this country..

 

[NacBooster29]

it was just a bj...look what this idiot we have now is doing to this country..

Wrong thread?!
But for the record I agree. LOL

 

[nrp3]

Its not that big of a change, just a couple of additional terminals that allow you put 12v or 120v into it. The transformer is an additional kit that comes with one relay.

 

[DIYer4Life]

So now you could use bell wire instead of romex to wire the contractors?

 

[nrp3]

Yes, for the relay coil.