Electrician Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
167 Posts
One issue I have found in paper mills that are pre 1960's is that many of the motor starters have 480V control voltage, usually just 2 phases from the starter to the push buttons in the control panel. Dangerous and not always marked clearly. On/off controls for pumps sometimes will not shut off when a high resistance ground is present on the phases used. Same for reversing starters.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top