Electrician Talk banner
1 - 4 of 4 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 ·
I'm going to give a price to a general contractor for a complete house re wire job from knob and tube. There are no prints for it. Should I make my own prints and submit them with the bid to show exactly what is included in my price? Then price according to the opening?
 

·
Registered
Joined
·
63 Posts
Discussion Starter · #3 ·
Something like this?
200 amp overhead service with 24 space panel
6 20 amp ckts
6 15 amp ckts
2 30 amp ckts
20 receptacles
6 single pole switches
4 120 volt smoke detectors
8 6" led recessed lights
2 dimmers

Basically show the quantity and device/task with 1 total price?
 

·
Registered
Joined
·
63 Posts
Discussion Starter · #6 ·
Sorry, forgot to mention it is a gut job. I guess I will go by code for receptacle and smoke detector locations and then talk with the home owner/general about lighting and switch locations. The kitchen will be done at a later time, waiting on cabinets, so I will have to find a way to feed it from the new panel temporarily.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top