Electrician Talk banner
1 - 20 of 34 Posts

·
Banned
Joined
·
1,073 Posts
I bet you made good money. You can't beat service changes.


Have you thought about using brady markers instead of white tape and writing the numbers on the wires? It might save you some time.
 

·
ET rocks
Joined
·
2,875 Posts
Mag, ATS on this one? What's the sealtite feed?

Would it kill ya to post the cover off pic?:whistling2:

Nice job.:thumbsup:
 

·
NJ-IEC
Joined
·
14,387 Posts
Discussion Starter · #16 ·
Mag, ATS on this one? What's the sealtite feed?

Would it kill ya to post the cover off pic?:whistling2:

Nice job.:thumbsup:
Yes, ATS on the exterior beneath new meter and all copper and pvc piping.

NO SERVICE ENTRANCE CABLE!!!! :no: :thumbup:

It started raining and snowing this afternoon so the generator is not complete yet but the trench is in and piping in place for the pull. :thumbsup:
 

·
NJ-IEC
Joined
·
14,387 Posts
Discussion Starter · #17 ·
Where is the pic with the new panel open? You know. Full of red wire nuts and butt splices.
It's actually not too bad in there except for one of the conduits contained (3) MWBC's that all wound up being short in the new panel. Otherwise I promise you all it is neat and tidy. I'll take a pic when I go back there.
 
1 - 20 of 34 Posts
Top