Electrician Talk banner

1 - 8 of 8 Posts

·
Registered
Joined
·
116 Posts
Discussion Starter #1 (Edited)
Looking for an idea to code compliantly fix this, I installed a 100amp disconnect in an old westinghouse piece of switchgear and after installing the disconnect there is a 1/4" gap between the disconnect and metal cover . Does anyone have any ideas how to cover this up easily? thanks

 

·
IBEW L.U. 1852
Joined
·
5,261 Posts
Does the NEC allow duct tape??:blink:
 
  • Like
Reactions: 51360

·
Small Potatoes
Joined
·
5,460 Posts
Assuming the switch you installed is approved for that switch gear I'd go back to the manufacturer and ask them.

Nice generator job by the way. What size is it?
 

·
animal lover /rat bastard
Joined
·
13,547 Posts
have a local metal shop make a bigger panel for the lower blank
 
  • Like
Reactions: Black Dog
1 - 8 of 8 Posts
Top