Joined
·
2,559 Posts
. There's absolutely no reason to ever do this . As long as the wire is stripped long enough ( so it doesn't bottom out on the insulation ) and the wire nut is tight , you'll never have an issue . I rarely pre twist solid . I almost always use ideal twisters and have the screwdriver that drives them .chrisg9265 said:I'm looking for a general consensus on the joining of two stranded wires...I've been doing electrical work for a good couple of years. I started a new job and in the last month I've found three people that believe that you should twist the wires (with your Klein's) prior to making a wire nut joint. I'm personally appalled!!!!!! I believe I've been well trained and I was always told your Klein's should never touch the copper prior to joining the joint. What's your thoughts???