[3xdad]

Got a call that immediately after start up, an Ecogen 6kW is shutting down with undervoltage message.

Need ET's help on what to look for first. Thanks.

 

[Wirenuting]

Bad board?

http://www.outbackpower.com/forum/viewtopic.php?f=17&t=4591&start=25

 

[bobelectric]

Oil pressure.

 

[480sparky]

Head to Grainger and buy some more volts for it. :laughing:

 

[3xdad]

Head to Grainger and buy some more volts for it. :laughing:

"Get it, got it, good."

Thanks for this useful post.:thumbup:

 

[bkmichael65]

Low engine speed? Maybe low gas pressure

 

[oldtimer]

Low engine speed? Maybe low gas pressure

Does it have a governor adjustment ?

 

[bobelectric]

Head to Grainger and buy some more volts for it. :laughing:

Good Answer, Charlie Weaver.

 

[nrp3]

There is no diagnostic manual for that unit. I would be inclined to see what the ohm reading is on 4 and 0. These are the leads to the brushes. See what you get. A really high reading, and I'd pull apart the back end to see whether the brush holder was in alignment with the slip rings or other damage. After that, condition of rotor and stator, maybe field boost.

 

[RFguy]

You may also want to check over at the Ziller Electric forum, The board is mainly Generac and have some helpful people.