Electrician Talk banner
Status
Not open for further replies.
1 - 20 of 28 Posts

·
ET rocks
Joined
·
2,875 Posts
Depends.

Trough, gutter, panel, j-box, etc. = You are an electrician, get it done mechanically brilliant.

Carlon plastic nail on for a 90deg sealtite conn. = Eh, not so sure.
 

·
Salty Member
Joined
·
31,081 Posts
Per UL it I impossible to 'void' a listing.

It is up to the AHJ to determine if the modifications are so great to require a field evaluation
 

·
Ambassador of Amps
Joined
·
9,518 Posts
Depends.

Trough, gutter, panel, j-box, etc. = You are an electrician, get it done mechanically brilliant.

Carlon plastic nail on for a 90deg sealtite conn. = Eh, not so sure.
if you bond the connector, its legal.:thumbsup:
 

·
Registered
Joined
·
10,316 Posts
Discussion Starter · #17 ·
I'll admit it. I'm bitter still over the time the inspector turned me down because I unibitted a hole in the rear of a deep blue carlon box and ran a piece of lfnm and a straight fitting into it
 

·
Registered
Joined
·
2,559 Posts
Cletis said:
Any listed enclosure where there is no or not enough pre-made knock outs
. Hmmm ? So a listed enclosure / wire way , that has no factory KO 's in it , just has to sit there and remain intact , hoping and dreaming someday a conduit or connector will be allowed to penetrate it , lol ? You're right , stop everything short , throw the box cover away , and fly your wires into the opening . As usual , you're on to something here , lol ! Happy thanksgiving !
 
1 - 20 of 28 Posts
Status
Not open for further replies.
Top